Why do programs crash or get stuck when the computer memory is clearly not full?

The first thing you need to do is to make sure that.

Please check your computer's various hardware configurations (mainly RAM) first to make sure that it is not due to too little RAM that is causing the memory to burst, and after you are sure, you can continue to browse the solutions below.

A common question that comes up for everyone.

The computer device still has memory left, but opening a few browser windows causes the memory to explode (at this point, the memory usage in the task manager is in the range of about 60% to 85%).

This could be caused by the virtual memory, you can try to set the virtual memory to solve the problem.

Setting up virtual memory

First, check the physical memory size of your device, right-click on the desktop “this computer” icon, and then you will see the following options.

Second, click on the picture in the “Properties”, you can see their computer's physical memory “Installed RAM”, that is, the physical size of your computer equipment, here you need to remember the size of the physical device, the back of the need to use this value to calculate.

Third, click on the “Advanced System Settings” in the above figure, the following figure.

Fourth, click on the “Settings” in the figure above, the figure below, “Performance Options” pop-up window, here switch to “Advanced”.

Fifth, switch to “Advanced”, click “Change” button, the following chart.

Six, click “Change”, according to the following picture on the steps.

Step 1: First click on “Custom Size”.

Step 2: In the “Initial Size” and “Maximum Size” two input boxes in order to fill in the value, the value of the calculation method:

Initial size = physical size * 1024

Maximum size = initial size * 2

Example: For example, if the physical device size of your computer device is 16GB, the initial size = 16 * 1024, the maximum size = 16 * 1024 * 2, here you need to pay attention to the actual physical device size to calculate the value. (Physical size query method to go to the second point above to view)

Step 3: After entering the value, click the “Set” button.

Step 4: After all the settings are completed, finally click the “OK” button.

Note: After the completion of the settings, turn off the program to restart and try again, if not resolved you can contact our official customer service to assist in processing!